How To Change Oil For 9.8 Tohatsu Outboard Motor Youtube

STEP-By-Pace LOWER UNIT OIL CHANGE

Welcome to the stride-by-step guide to changing your outboard's lower unit oil. This 8-step process is all it takes to ensure the oil in your lower unit is properly maintained.

The chart at the end of this guide lists the approximate amount of oil needed to make full the lower unit of each model currently offered by Tohatsu.

Footstep

First, exist sure your outboard is in a vertical and upright position.
Locate and place the upper and lower Fill & Bleed Plugs.
Identify an oil drain pan beneath the outboard.

STEP

Remove the Bottom drain plug first (not the top).

Some oil will begin to trickle out so be sure your oil drain pan is positioned correctly to catch the draining oil.

Footstep

Next, remove the TOP drain plug.

This will release the vacuum that exists and let the oil to drain freely from the lower unit.

STEP

Permit all of the oil drain completely from the lower unit of measurement.

This will take near 5-ten minutes.

Pace

Once all the oil has completely drained out it is time to refill the lower unit of measurement. There are several types of apparatuses bachelor ranging from clasp bottles to tubes. One of the more popular "do-it-yourself" methods is to apply a squeeze bottle.

Y'all can use any brand of lubricant that has a grade designation of API GL5 SAE lxxx or ninety weight. Make sure you practice not mix different oil brands or weights.

To refill the lower unit, insert the bottle/tube
into the BOTTOM drain hole. And so slowly clasp the bottle to force the oil into the lower unit of measurement.

STEP

Continue adding oil until the lubricant is flowing freely from the meridian pigsty and is gratis from air bubbling.

Step

Proceed the bottle/tube in the lesser plug (or plug the hole with your finger) and re-install the Tiptop plug.

This volition create a slight vacuum that will minimize the oil loss while you lot reinstall the bottom plug.

Stride

Now, QUICKLY remove the bottle (or your finger) from the bottom pigsty and install the drain plug. It is important to do this equally quickly as possible to minimize the corporeality of oil loss. Fifty-fifty though there is a slight vacuum, at that place volition still be some loss of oil. Do not be concerned well-nigh losing some oil, however, if you lose an excessive corporeality of oil you volition demand to go dorsum and add additional oil. Hand tighten both the lower and upper drain plugs and wipe off any oil on your lower unit.

Alert: Running your outboard without completely filling the lower unit of measurement with oil to the proper level will cause severe damage to your outboard. See the comments at the finish of this guide on how to cheque for the proper oil level in your lower unit.

Be sure and properly dispose of your onetime oil by taking information technology to an oil recycling centre. Almost "quick lube" oil modify centers or auto service stations will accept your used oil for a nominal fee.

Comments: To check your oil level, remove the summit oil plug, insert a small piece of wire straight into the elevation hole approximately 1 inch and withdraw the wire. If oil is on the wire the oil level is correct, if not the unit must exist refilled to the correct level.

To add together ("top-off") oil install the top plug once again, remove the bottom plug and put your oil bottle into the hole. Remove the pinnacle plug to release the vacuum and add the necessary corporeality of oil. Reinstall the top plug, then apace reinstall the bottom plug. Check the oil level one time again as described to a higher place.

Our Outboards

We are uncompromising in our pursuit of outboard motors that are both durable and every bit light as possible. We pursue the ultimate in quality to deliver an inspirational engine feel.

• Find the series

Source: https://tohatsu.com/marine/int/tech_info/oil_change.html

Posted by: rogersthoing.blogspot.com

Share this post